250A Busbar Clamps

250A busbar clamps is suitable for copper bars and cables of various specifications. Its maximum current can reach 2500 A. It is widely used in low voltage control systems and industrial control systems.

250A busbar clamps is widely used in busbar system.,Busbar system is mainly used in low-voltage power distribution cabinet. The inlet and outlet circuit adopts non-porous electrical installation technology. Switches are connected to buses through bus adapters. Copper bar is not only the conductor but also the support of electrical components and is enclosed behind.

The 250A Busbar Clamps connect round conductors with bus bars 20 x 5 mm up to 30 x 10 mm without the need for any drilling. Type II terminals connect insulated supple bars and also solid bars using bus bars 20 x 5 mm up to 30 x 10 mm, again without drilling. Type III terminals connect switch gear with latch 30 mm width and drilling M12 and round or flat connectors.
The jaw type terminals make it possible for the bus bar to be gripped properly. The conductors can be connected without drilling. If aluminium connectors are used, the connection has to be inspected periodically.